A numerical example
Draw a 20.00 mm square with no compensation. If the removed square measures 19.80 mm, the estimated full kerf is 0.20 mm. Half of that width lies on each side of the commanded path. An outward path displacement of about 0.10 mm on each edge would restore the external dimension in this simplified example.
Repeat cuts and measurements: caliper pressure, taper, char and surface roughness affect the result. These numbers illustrate the geometry; they are not recommended settings for your machine.
Why a slot test is also necessary
A sheet sold as 3 mm may have a different measured thickness. Kerf and thickness are separate: one concerns material removed during cutting; the other concerns the stock you are fitting into the slot.
- Measure the sheet at several points.
- Cut a small range of slot widths around the measured thickness.
- Label each width and keep machine settings constant.
- Test the fit you need: loose assembly, glue joint or press fit.
- Repeat when the material batch, lens, focus or settings change.
Apply compensation once
Keep an uncompensated master. Choose either geometry offsets in the design or kerf compensation in the machine software, and record the choice. Combining both can make tabs too large and holes too small.
LightBurn applies kerf offset to the generated toolpath rather than rewriting the source geometry. Its offset behavior relies on closed shapes. Read the current software documentation before entering a value; a field labelled kerf width may expect a different value from a field labelled path offset.
Fit problems that kerf will not solve
Scaling an entire box changes tab spacing and panel dimensions as well as slot widths. It is usually a poor substitute for changing the joint geometry. Check units, stock thickness and whether the paths are closed before changing compensation.
For repeat production, keep a labelled test coupon with the sheet batch and settings. For a custom assembly, our laser cut file service needs your machine, bed size, measured material thickness and required finished dimensions. Physical testing remains necessary.
Sources and scope
Product behavior was checked against these primary references. Software features can change.
Examples and workflow recommendations are written by AllThingsVector. Inspect every export in the receiving software and test the final design. Editorial approach and corrections.