How to add stencil bridges so letter centres stay attached

Keep the centres of A, B and O in your stencil with deliberate bridges, a connected frame and a check at the final cut size.

Think about what stays on the sheet

In a stencil, the letter opening is removed and paint passes through it. The centre of an O is surrounded by that opening, so it falls away unless a strip connects it back to the sheet. A B has two separate centres; both need a connection.

A positive name sign works differently: you keep the letters, not the surrounding sheet. Decide which material is retained before adding bridges. A design that works as a vinyl decal may fail as a reusable stencil.

An island-by-island inspection

  1. Set the finished width and height before judging small details.
  2. Find every enclosed piece, including counters, eyes and small decorative centres.
  3. Add a bridge that connects each piece to material you intend to keep.
  4. Check for new fragile necks where bridges meet curves or corners.
  5. Export and inspect the real paths. A coloured preview overlay alone does not prevent a cut.

Our stencil tool is a starting point. Inspect the generated result, especially nested details, small lettering and complex imported art.

Choose a width by testing

There is no universal bridge width. A larger island places more stress on its connections. Material flexibility, grain, cutting process and repeated cleaning all change what survives.

For a simple test, draw three copies of the same O at the intended size with progressively wider bridges. Cut them from the intended stock and compare handling and paint results. Label the widths. If the smallest survives one lift but tears during cleaning, it is unsuitable for a reusable stencil.

Permanent bridges versus holding tabs

A stencil bridge remains in the finished design and produces a gap in the painted shape. A laser holding tab is a short skipped cut intended to keep a part in the sheet until you remove it. LightBurn documents these tabs separately. Do not substitute break-away tabs for a permanent stencil connection.

For an intricate logo, simplify tiny islands and place bridges where the interruption least harms recognition. Use custom cut-file design when the artwork needs deliberate reconstruction. Always confirm the stock is approved for your cutting process.

Sources and scope

Product behavior was checked against these primary references. Software features can change.

Examples and workflow recommendations are written by AllThingsVector. Inspect every export in the receiving software and test the final design. Editorial approach and corrections.