Centerline vs outline tracing: why your drawing has double lines

Choose a single stroke for scoring or a closed outline for cutting, and distinguish outline tracing from duplicate laser paths.

Two edges are not necessarily duplicate paths

Imagine drawing a thick black S with a marker. An outline trace encloses the whole strip of ink, so the path goes down one side and back along the other. That is correct for a filled black S, but it looks like two lines when assigned to a scoring operation.

A duplicated path is different: two objects follow the same location. Removing duplicates will not turn the two legitimate edges of a marker stroke into its centre. For repeated passes on the same location, see why a laser cuts the same line twice.

Choose based on the operation

GoalStarting geometryCheck
Cut a solid silhouetteClosed outlineInside holes and outside boundaries
Draw handwriting with a penCenterline strokesUnwanted branches and repeated strokes
Score a line illustrationCenterline or deliberately drawn pathsTravel sequence and tiny offshoots
Engrave a filled logoFilled geometry or raster imageFill settings and final size

Prepare the source for a cleaner centre

Use a sharp scan with strong contrast and a plain background. Remove dust and separate unrelated marks before tracing. Start with simple line art rather than a shaded photograph.

At a junction, mathematical skeleton tracing can create branches that do not match the stroke you would draw by hand. Thick blobs and inconsistent line widths make this more likely. LightBurn’s centerline documentation also cautions about offshoots in low-resolution sources.

Inspect the result before scoring

Compare the ends of strokes, junctions and small loops against the original. Delete spurs deliberately, join only the ends that should connect, and check the machine preview at its actual size. An open path is appropriate for a drawn line, even though it would be inappropriate as the perimeter of a cut-out part.

A centerline tool cannot reliably infer the original writing order from a photograph. If you need an exact single-stroke logo or a particular motion sequence, ask for custom vector artwork and state that requirement in the brief.

Sources and scope

Product behavior was checked against these primary references. Software features can change.

Examples and workflow recommendations are written by AllThingsVector. Inspect every export in the receiving software and test the final design. Editorial approach and corrections.